CST BrandsEZ- Auth Payment Terminal Running Fleet TransactionsHow do I run a Fleet Transaction using a Fleet / Credit Card?

How do I run a Fleet Transaction using a Fleet / Credit Card?

In this lesson, you will learn how to run a Truck Fleet Transaction using a Fleet / Credit Card

Select New Fleet Transaction

Touch the New Fleet button on the Register Display

Card Swipe Prompt

The Register will bring up a notification asking the customer to swipe their card

Note: On the MX 915 (EMV) Pin Pad, some Fleet Customers will be required to keep their card inserted in the MX915 Pin Pad slot through the whole process of entering the Customer's Information for the Truck Fleet Transaction.

Pre-Edit Fuel Type

Fuel Selection Steps:

(1) Select Dispenser. In this example we have chosen dispenser 5. In this example, the driver is getting diesel fuel only.  So, we will touch the "Truck" button.

(2) Touch "Truck" is the driver is getting diesel fuel only.

(3) Select "Accept" once the Fuel Selection has been made

Touch "Reefer" if the driver is getting reefer fuel only.

Touch "Both" if the driver is getting both diesel and reefer fuel.

Touch "None" if the driver is not getting either type of fuel.

Note: If Customer is using a Bank Card you may get a System Message on your Register to enter the Maximum Sale Amount

Fleet Data Entry

On the Fleet Data Entry screen, enter the necessary driver information.  The only fields available will be those that are required by the card processor.

In this example, Comdata requires the (1) Company Name, (2) Truck Number, and (3) Driver Number information.  

(4) Once you have entered the driver's information touch the FUEL DISP button.

Note: The required information to enter will vary depending on card tyype.

Authorize

You will see a message pop up on the screen confirming that the dispenser is now authorized. The driver can now dispense fuel.

Completing the Fleet Transaction

Once the driver has finished fueling, you will need to find the transaction in the list of Pending Fleet Transactions. Touch the Pending Fleet button to pull up the list of Pending Fleet Transactions.

Select the Transaction

(1) Touch the transaction to highlight it in the list.

(2) Touch the "Select" button.

Ring Sale

The fuel is released and is ready to be rang into the register. Touch the Ring Sale button.

Loyalty Card Prompt

You will be prompted to swipe a loyalty card if the customer has one that is accepted at your location.

Swipe the loyalty card the press OK or Touch the Cancel button.

Tender the Transacation

Press the Tender method that was used at the start of the transaction.

For Example, If Credit was the method tendered you would touch the Credit button and have the customer either swipe or insert their card into the MX 915 (EMV) Pinpad Card Reader Slot

Once the card is inserted into the MX915 Pinpad Slot. Credit, Debit, EBT buttons will be displayed on the MX 915 pinpad.

For Credit transaction, the "Select Credit" message on the MX 915 Pinpad will be displayed.

Press YES if amount is correct

If a PIN is required, a message Please enter your PIN will be displayed.

Enter PIN, and press Enter.

Note:  When using Fleet Cards such as COMDATA, Fleet One or EFS the customer will be asked for additional information such as their Driver ID

After driver enters the PIN into the MX 915 Pinpad, the message "Please Wait, Do Not Remove Card" will then be displayed on the pinpad

Requesting Credit

The register will display a System Message that the transaction information is being sent to the credit card processoer.

If a signature is required, a signature box will be displayed on the Pinpad

Once the transaction is approved a TFT receipt will print for the customer.

0 Comments

Add your comment

E-Mail me when someone replies to this comment